A pad cut to fit AM4 and AM5 Ryzen heat spreaders
Unveiled on 12 November, the NT-CP1 sits between the processor’s metal heat spreader and the base of the cooler. Its aluminium substrate carries carbon nanotubes and a phase-change polymer coating. The square format leaves the edges of the processor clear. To fit it, centre the pad on the heat spreader, press it down and remove its protective film before installing the cooler. Noctua’s announcement · NT-CP1 specifications. The Ryzen 7 9800X3D is one example of a socket AM5 processor.
With a nominal thickness of 0.09 mm, the NT-CP1 is intended for two surfaces that are already very close together. The thick, compliant pads that bridge a gap between a heatsink and the chips on an SSD or graphics card serve a different purpose. Noctua explicitly rules out that use for the NT-CP1. Applications listed in the FAQ.
Why it takes time before temperatures can be compared
As the system heats up and cools down, the coating and nanotubes gradually conform to microscopic irregularities on both surfaces. In its own tests, Noctua says the pad reached full performance after around 300 cycles in some setups and more than 3,000 in others. A reading immediately after installation therefore shows how the pad behaves when new. Converting cycles into weeks would require knowing how the machine is actually used. Noctua’s measurements and test method. A cycle consists of heating the processor above 60°C, which slightly softens the pad’s polymer coating, then cooling it below 50°C so the coating solidifies again. Noctua also supplies an automated .bat script that uses Prime95 to speed up thermal bedding-in.
The manufacturer highlights the stability of the contact once bedding-in is complete. It does not promise the same temperature difference on every processor. The flatness of the base and the mounting pressure matter too. Carbice describes its technology as an adaptation of the nanotube interfaces it developed for aerospace applications. Carbice’s overview.
What happens if you change the CPU cooler?
The FAQ gives a more nuanced answer than a blanket recommendation to replace the pad. According to Noctua, an intact pad can sometimes be reused. However, the manufacturer does not guarantee its effectiveness after removal and advises against reuse in critical systems. This is particularly relevant to anyone who frequently swaps coolers to compare setups. Noctua’s answer on reuse.
The recommended launch price of €24.95 applies to the NT-CP1 AM5/4. Noctua links directly to its French product listing in its list of retailers. View the Noctua NT-CP1 AM5/4 on Amazon.fr (affiliate link).
Key takeaways
For a Ryzen system whose cooler will stay fitted for a long time, the NT-CP1 replaces the need to measure out paste with a pre-cut pad and a bedding-in period. On a test bench that is regularly taken apart, the cost of each fresh interface weighs more heavily in the comparison.